Circontrol Wallbox eNext Series Installation Manual page 16

Wallbox eNext Series Installation Manual
5
Material:
•
•
•
Tools:
Screw driver
(*) Ratchet tool can be used to open/close the Charge Point if required by the conditions of
installation.
12
Allen wrench of 2,5 mm is included in the installation kit.
Screws, sealing washers and plastic anchors are not included.
The fastening system of the Charge Point has been designed to be installed
on a wall.
» This system has been tested on a concrete wall, to be securely fixed in
such conditions is recommended to use:
3 x Inox A2 wall screws: DIN 7982 Ø4,8x3
3 x plastic anchors: 6x40 or 8x40
» If the wall surface has different properties, the screws and plastic
anchors must be defined by a qualified installer.
Ratchet*
2.5mm Allen
Driller
Tap drill 6/8M