HMS BE3601-i Manual Instruction page 25

Operation instruction
Warning: Improper connection with the grounding conductor may result in the risk of
electronic shock. When you are in doubt if the treadmill if properly grounded, professional electrician or
repairman should be required to inspect it. Do not fix the original plug, if there is no proper socket
available, you should turn to professional electrician to install a proper one.
Adjustment instruction
1．The serviceman or the professional should check if voltage is suitable before connecting power, if grounded wire of
three-core plug is well connected. Use hand to pull the running belt to check if rotation is flexible and there is no noise.
2．Connect power, press Start key, treadmill will run slowly, inspect if belt and computer are normal.
3．Press incline +/- key, inspect treadmill rotation and display. If the belt is deviation, you must stop it to adjust belt
4. Pressing emergency stop key or pull out safety key when the treadmill is running, it will stop immediately. Reinsert
the safety key so that the emergency stop button is up and reset, then you can restart the treadmill. (As the below
The treadmill can be used after finishing all the adjustments.
2．Stand with your feet on both side rails and clip the other end of
safety key to your clothes of waist.
2．Press Start key, the treadmill will run slowly, you can step on belt
slowly.
3．Press speed+ key, the belt speed will gradually increase, the
speed value can be seen in the computer, it's suggested to run at low
speed for 2-3 minutes, then press your target speed, after getting use
to the running pace , you can release the handrail to run.
4 ． You should slow down gradually and keep running for 2-3
minutes at low speed before stop running, which will help the heart
and breathe back to normal.
5. At the end of run, you can reduce the speed to the lowest, then
press stop key to stop the treadmill.
6.If it is too late to reduce speed and lose balance in high speed
running, you can pat the emergency stop,then the treadmill will stop to run immediately. Its stopping distance depends
on inertia weight.
according to the maintenance instruction.
figure).
24