Assembling; Housing Cover And Pcb - Proceq Hygropin Service Manual & Repair Manual

5. Assembling

5.1 Housing cover and PCB

1
2
3
4
Doc: 820 78 004E Rev: 03
© Copyright 2017, Proceq SA, CH-8603 Schwerzenbach
Filename: 20171204 Service & Repair Guide Hygropin v03.docx
Attention :
Before handling the electronic components of the
Profoscope be sure to wear the ESD wrist strap.
Material :
1 Housing Cover
1 Keypad
1 MMI PCB complete
1 Screw Crosshead for PCB
Procedure :
Before you start with assembling make sure the
keypad is in the housing cover.
Place PCB into housing cover
Procedure :
Remove the protective foil from the display.
Place the PCB in the cover by sliding the plastic
anchors of the housing into the opening in the PCB.
Connect probe interfaces with PCB
Procedure :
Connect the probe interface connectors carefully to
the according counterpart on the PCB. Make sure
the inputs for probe1 and probe2 are in the right
order.
Tool :
1 Screw Driver Crosshead small
Procedure :
Fix the PCB in place using the screw.
Components list
Fix PCB with screw
Page 7/14
Working copy if printed