Changing The Transfer Belt - Xante CL30 User Manual

All manuals and user guides at all-guides.com

CHANGING THE TRANSFER BELT

When the transfer belt reaches the end of its life,
is displayed in the control panel. The transfer belt life is
approximately 80,000 sheets, letter long edge feed. However, this
assumes a standard print job of three sheets. If single sheets are
printed, transfer belt life is reduced.
1. Switch off the printer and open the top cover.
2. Remove all four image drums/toner cartridges from the printer
and place them on a flat surface (to prevent damage to the shiny
green drum surface); then cover them to protect them from light
while you are replacing the transfer belt.
Chapter 10 - Maintenance • 167
CHANGE BELT UNIT