Table of Contents
Advertisement
8
TTY Interface
The TTY interface is the NetGuardian AAR's built-in interface for basic configuration. From the TTY interface, you
can:
· Edit the IPA, subnet, and gateway
· Configure primary port
· Set unit back to factory defaults
For more advanced configuration tools, please use the Web Browser Interface.
For Telnet, connect to the IP address at port 2002 to access the configuration menus after initial LAN/WAN setup.
Telnet sessions are established at port 2002, not the standard Telnet port as an added security measure.
If you're using Windows 7, then you'll need to install telnet before you can use the TTY interface. To install telnet,
open up your command line (type "cmd" into the search bar in the Start Menu). Select cmd.exe to run the
command line.
From the command line, type in pkgmgr /iu:"TelnetClient" then press enter. When the command prompt
appears again, the installation is complete.
Menu Shortcut Keys
The letters before or enclosed in parentheses () are menu shortcut keys. Press the shortcut key to access that
option. Pressing the ESC key will always bring you back to the previous level. Entries are not case sensitive.
· Set DCP info for T/Mon polling
· Ping other devices on the network
· Debug and troubleshoot
23
Advertisement
Table of Contents
Need help?
Do you have a question about the NetGuardian AAR HC and is the answer not in the manual?
Questions and answers