Elcometer Novo-Gloss 406 Operating Instructions Manual page 19

The display will show the following screen for 2 seconds:
The display will then revert to measurement mode.
2. Press and hold the ANGLE CHANGE/CANCEL button for two seconds or use the SCROLL UP/DOWN
button to select:
3. Press the READ/SELECT button to start the procedure.
4. Press the READ/SELECT key to confirm the selection. The display will read:
5. Place the gauge carefully on the zero value foam, which is located in the lid of the calibration standard
(Figure 7).
6. Press the READ/SELECT key to set the zero value.
Elcometer 406
Mini Glossmeter
ANGLE Value No.
60° 0 0
TO CALIBRATE
Press Read Key
ARE YOU SURE?
Press Read Key
CALIBRATE
Sample Zero Ref
17