Sega MISSION: IMPOSSIBLE Owner's Manual page 70

4
Using a sharp knife or blade, carefully remove the protective sleeve from around the solder joint. Unsolder
the ORG and BLK wires, taking note of their positionings
Protective sleeves
5
Replace the switch and re solder the wires onto the new switch in their correct locations. Ensure that the
protective sleeves are also replaced
6
Reassemble the Controller unit following these instructions in reverse order. Check operation using the
OUTPUT TEST MODE in section 9 of this Manual
Solder joints
1 - BLK
4 - ORG
2 - Not Used
11
61