Sega MISSION: IMPOSSIBLE Owner's Manual page 11

• Do not touch undesignated places. Touching places not designated can
cause electric shock or short circuit
• Whenever any fasteners (e.g. screws, nuts) have been lost, be sure to use
replacement fasteners with proper dimensions as specified in this Manual.
If fasteners of any other dimensions are used, it could cause damage
1 1
and/or separation of parts that result in secondary accidents
• Specification changes, removal of equipment, conversion and/or
addition, not designated by SEGA are not permitted
• Failure to observe this may cause a fire or an electric shock. Non-
compliance with this instruction can have a bad influence upon the
physical conditions of players and onlookers, or result in injury during
play
• SEGA shall not be held responsible for damage or compensation for
damage to a third party caused by specification changes not designated
by SEGA
• Performing work or parts replacements not described in this Manual
could result in accidents. If you need to perform any work not listed in
this manual, request work from the office indicated in this manual or the
point-of-purchase, or inquires for details
• Be sure to perform periodic maintenance inspections herein stated
• For the IC board circuit inspections, only the use of a logic tester is
recommended. Using a Multi-Tester or General Purpose Tester may result
in damage to IC Circuits
• Static electricity from your body may damage some electronic devices
on the IC board. Before handling the IC board, touch a grounded metallic
surface so that the static electricity can be discharged
• Some parts are not designed or manufactured specifically for this game
machine. The manufacturers may discontinue or change the specifications
of such general-purpose parts. If this is the case, SEGA cannot repair or
replace a failed game machine whether or not a warranty period has
expired
2