Troubleshooting; Failure Display Codes - Samsung NX58K9850S Series Service Manual

4. Troubleshooting

4. Troubleshooting

4-1 Failure Display Codes

There are two kinds of error codes. One denotes an oven temperature sensor error and
the other denotes a safety error. Possible error codes during use can be checked before service.
1 . Touch Clock pad .
2 . Touch the number pads 1,2,3 and 4 . Make sure the Timer and
Warming Drawer are both turned OFF .
3 . Touch the Start/Set pad .
4 . Touch the 'Clock' and the 'Touch to Wake-Up' pads at the same time for 2 seconds .
Error codes are displayed .
5 . Press the 0 number pad, to display the latest 5 error codes . But, if the power is
interrupted and the oven turns off, the stored
6 . Press the Off/Clear pad to return to normal display mode .
Oven Sensor information
Informaion code
Oven sensor opened
C-20
Oven sensor shorted .
This document can not be used without Samsung's authorization.
error codes are deleted .
Meaning
1 . Disconnect power . Open the back cover . D isconnect sensor
harness from control Measure sensor resistance :1080Ω at
the room temperature .
→ If there are any problems, replace oven sensor .
(over 2950Ω)
2 . If there is not any problem with oven sensor,
Please check whether there is a damaged
terminal or wire harness .
(Under 930Ω)
3 . Check resistance of oven sensor connector on
main PCB (Normal:2850Ω)
SOLUTION
69