Sensor-Thermister - Samsung NX58K9850S Series Service Manual

3. Disassembly and Reassembly

3-20 SENSOR-THERMISTER

WARNING
Disconnect power before servicing the range . Replace all panels before operating range . Failure to do so
can result in death or electrical shock .
WARNING
EXPLOSION, FIRE, AND ASPHYXIATION HAZARD
Shut off gas supply to the range before servicing. Check all gas lines and fittings for leaks before operating
the range . Replace all panels before operating range . Failure to do so can result in death or personal injury
from explosion, fire, or asphyxiation.
CAUTION
When you work on the gas range, be careful when handling sheet metal parts . Sharp edges may be present,
and you can cut yourself if you are not careful .
Parts
1 . Follow steps on 3-1
2 . Open the oven door and remove
the racks from inside the oven .
3 . Disconnect connector of the
sensor thermistor to the rear of
the range .
4 . The oven sensor thermistor is
in the upper left-hand corner
of the
2 screws and carefully pull the
Sensor-
sensor wire leads until the wire
Thermister
connectors appear .
5 . Reverse the order to install the
oven temperature sensor .
If you can't access the wire
connectors from inside the
oven, remove the rear cover
panel . Mark and disconnect the
two wires going to the oven
sensor thermistor .
This document can not be used without Samsung's authorization.
Explanation
oven cavity . Remove
Explanation Photo
Connector
45
4
4