Samsung NX58K9850S Series Service Manual page 74

4. Troubleshooting
Failure Display Codes
Safety error
"C-d0"
*Disconnect power .
*Take out the assy ITO glass from the display PCB .
*Check for shorted circuit between connector pins
and pins on display PCB .
Yes
*Make sure whether between FPCB pin
and pin on assy ITO glass
have a short circuit .
This document can not be used without Samsung's authorization.
Key Connector
(CN201)
74
Assy display PCB
FPCB
Assy ITO glass
* Repair the area of the circuit with
shorted connector pins on Main PCB .
* Repair or replace the board if damage
No
or circuit is shorted between micom
and connector .
No
*Replace or repair control box .
Control box
END
END