Table of Contents
Advertisement
M26
K Factor
The calibration factor is used to
modify the measurement results.
The user can enter a numerical
value (except "1") according to the
actual calibration results.
M27
Correction
KArray
Sectional correction
ON: opening the sectional correction
OFF: closing the sectional correction
For the "Delay" submenu, you
should use the factory settings.
TPC
Transducer power control
Use the factory setting.
0. Auto
1. Low
2. High
M28
SQA
Statistical analysis
© PCE Instruments
24
Advertisement
Table of Contents
