Connecting To The Network - Emerson RSTi-OM User Manual

RSTi-OM User Manual
GFK-3212A
2.1.2

Connecting to the Network

The IOLM provides two Fast Ethernet (10/100BASE-TX) M12, 4-pin female D-coded connectors.
Figure 4: IOLM Fast Ethernet Connectors Pinout
You can use this procedure to connect the IOLM to the network.
1. Securely connect one end of a shielded twisted-pair (Cat 5 or higher) M12 Ethernet cable to
2. Connect the other end of the cable to the network.
3. Optionally, use the other Ethernet port to daisy-chain to another Ethernet device.
4. If you did not connect both Ethernet ports, make sure that the unused port is covered with a
Note: Ethernet ports must have an approved cable or protective cover attached to the connector to
guarantee IP67 integrity.
Configuring
either Ethernet port.
connector cap to keep dust and liquids from getting in the connector.
Pin Signal
1 Tx+
2 Rx+
3 Tx-
4 Rx-
Section 3
Jun 2021
12