Table of Contents
Advertisement
SH SOLAR G, GH, GW
5.7.3 Building and equipment
Task
General surfaces
Metallic equip-
ment
Rusted or dam-
aged surfaces
prior to treatment
These are merely several examples of cleaning tasks that can be solved by a pressure washer in as-
sociation with accessories and deteregents. Each cleaning task is diff erent. Please consult your local
dealer or Nilfi sk representative in order to discuss the best solution for your own cleaning tasks.
6 Maintenance
22
Accessories
Foam injectors
Standard lance
Curved lances
Tank cleaning head
Detergents
Intensive
J25 Multi
Combi Aktive
Alkafoam
Disinfectant
DES 3000
Wet sand blasting equip-
ment
To ensure the most optimal
maintenance of your machine,
you should consider making a
"Service Contract" with Nilfi sk.
In this way your machine will
always be ahead of potential
problems.
Though paying attention to a
few things will ensure a pro-
longed and reliable operation of
your machine. Therefore it will
be a good idea to make a habit
of the following:
Method
1. Apply thick foam over the surfaces to be cleaned.
Apply on dry surfaces. Apply from top to bottom
on vertical surfaces. Let the foam act for up to 30
minutes for the optimal eff ect.
2. Proceed with cleaning using the high pressure
lance. Use applicable accessories. Use high
pressure to dislodge large amounts of incrusted
dirt or grime. Use lower pressure and high water
volume in order to rapidly fl ush away loose dirt
and rinse surfaces.
3. Apply DES 3000 disinfectant once the surfaces
are perfectly clean.
Areas covered by amounts of loose dirt, such as
animal remains in slaughterhouses, can be removed
by using high water fl ow to fl ush away the dirt to
evacuation pits or drains.
Tank cleaning heads can be used to clean barrels,
vats, mixing tanks etc. Cleaning heads may be
hydraulically or electrically powered and give the
possibility for automatic cleaning without a constant
user.
1. Connect the sand blasting lance to the pressure
washer and place the suction tube in the sand.
2. Always wear protective equipment during sand
blasting.
3. Spray the surfaces to betreated with the mix of
water and sand. Rust, paint etc will be stripped
off .
Prior to attaching the water
hose and the high pressure
hose, the quick couplings
should be cleaned of dust and
sand. Flush if necessary. This
will prevent premature clogging
of fi lters.
Prior to attaching the spray
lance or other accessories to
the spray handle, the machine
should be started and the quick
coupling cleaned of dust and
sand.
Original Instructions
Advertisement
Table of Contents
