Table of Contents
Advertisement
2 Description
2.1
Application
2.2
Operation elements
3 Installation
3.1
Installation conditions
Original Instructions
This high pressure hot water
washer has been developed
for stationary installation and
professional use within:
- agriculture
- light industry
- transport
- building and construction
- service
Section 4 describes how to use
the high pressure hot water
washer.
See illustration at the end of the manual
1 High pressure outlet (quick coupling, male)
2 Main switch
3 Start push button (illuminated, green)
4 Stop push botton (illuminaded, red)
5 Heating ON/OFF push button (illuminated, yellow)
6 Pressure gauge
7 Water inlet (quick coupling, female)
8 Thermostat (temperature adjustment)
9 Electric cable
10 Inspection window (hour counters, error messages)
11 Chimney
12 Data plate
13 Measuring point, exhaust gases
14 Overheat fuse - resetable
Max 40 °C
Min
Only use the high pressure
hot water washer for purposes
described in this manual.
The safety precautions must be
observed to prevent damage
to the machine, the surface to
be cleaned or severe personal
injuries.
The machine should be in-
stalled in a frost-free room.
This applies to pump as well as
pipelines incl. of outlet points.
If connected to outdoor outlet
points it should be possible to
close and emp ty that part of the
2 °C
line which is exposed to frost.
The maximum ambient tempe-
rature for the machine is 40°C.
Air humidity: max. 80% relative
humidity.
SH SOLAR G, GH, GW
5
Advertisement
Table of Contents
