Typical Cleaning Tasks - Nilfisk-Advance SH SOLAR G Instructions For Use Manual

5.7

Typical cleaning tasks

5.7.1 Agriculture
Task Accessories
Stables Chemical foam injectors
Pig pens, sties Foam lance
Powerspeed lance
Cleaning of walls, Floor cleaner
fl oors and equip-
ment Detergents
Universal
Disinfectant Alkafoam
Disinfectant
DES 3000
Machinery Detergent injection
Tractors Powerspeed lances
Ploughs etc. Curved lances and un-
derchassis washers
Brushes
5.7.2 Vehicle
Task Accessories
Vehicle body- Standard lance
work Detergent injection
Curved lances and un-
derchassis washers
Brushes
Detergents
Active Shampoo
Active Foam
Sapphire
Super Plus
Aktive Wax
Allosil
RimTop
Original Instructions
Method
1. Soaking - apply foam to all surfaces (bottom to
top) and wait for approx. 30 minutes.
2. Remove the dirt from surface with the high pres-
sure lance or chosen accessory. Again, clean from
bottom to top on vertical surfaces.
3. To fl ush away large quantities of dirt, change to
low pressure mode and use the higher fl ow to
push away the dirt.
4. Use recommended disinfectant products and
methods to ensure hygiene. Apply DES 3000
disinfectant once the surfaces are perfectly clean.
1. Apply detergent to vehicle or equipment surfaces
in order to soften up dirt and grime. Apply from
bottom to top.
2. Proceed with cleaning using the high pressure
lance. Clean again from bottom to top. Use ac-
cessories to clean in diffi cult to reach places.
3. Clean fragile areas such as motors, rubber at
lower pressure levels to avoid damage.
Method
1. Apply detergent to vehicle or equipment surfaces
in order to soften up dirt and grime. Apply from
bottom to top. In cases of particularly dirty vehi-
cles, pre-spray with a product such as Allosil in
order to remove traces of insects etc, then rinse
at low pressure and apply normal car cleaning
detergent. Let detergents settle for 5 minutes
before cleaning off . Metallic surfaces can be
cleaned using RimTop.
2. Proceed with cleaning using the high pressure
lance. Clean again from bottom to top. Use ac-
cessories to clean in diffi cult to reach places. Use
brushes in order to add a mechanical cleaning
eff ect. Short lances can help for cleaning of mo-
tors and wheel arches. Curved lances or under-
carriage washers can be valuable for the cleaning
of car under-chassis and wheel arches.
3. Clean fragile areas such as motors, rubber at
lower pressure levels to avoid damage.
4. Apply a liquid wax using the pressure washer in
order to protect the bodywork from pollution.
SH SOLAR G, GH, GW
21