Adjusting The Angle Of The Push Bar; Seat Adjustments; Adjusting The Seat Depth; Width Adjustment Seat - Invacare rea Azalea Assist User Manual

3.8.2 Adjusting the angle of the push bar

B
1. Press the buttons A.
2. Adjust the push bar B to the preferred angle.
3. Release the buttons A.
Move the push bar slightly in order for the buttons
to lock into position.
WARNING!
Risk of imbalance
– Do not hang anything on the push bar, this
could cause imbalance.

3.9 Seat Adjustments

The seat depth of the chair can easily be adjusted to provide
good support. The width between the leg rests and armrests
and the height of the armrests can also be adjusted.
Depends of the cushion model, some seat cushion A can be
secured with hook and loop straps B on the seat plate.
WARNING!
Risk of seat cushion sliding
– Make sure that the hook and loop straps are
pressed firmly together and make sure that
they stay fixated.
1488727-R
A
A
B

3.9.1 Adjusting the seat depth

1. Remove the seat cushion.
2. Loosen the screws A with an 5 mm Allen key.
3. Move the front edge of the seat forwards or backwards.
4. Re-tighten the screws A (5–6 Nm).
5. Put the seat cushion back.
The distance between the back of the knee/calf
and the cushion should be as small as possible, but
without contact.

3.9.2 Width adjustment seat

A
1. Loosen the screw A with an Allen key.
Tools: 5 mm Allen Key
2. Adjust the armrests to the desired width.
3. Re-tighten the screw A.
Risk of poor adjustment
– There must not be any pressure on the armrest
/ legrest while adjusting the screw.
Width adjustment leg rest
Product Overview
15