EMS SmartCell Programming Manual page 65

Dual input / output device
Attribute type
Address number
Device Display Text
O/P 1 OFF
O/P 2 OFF
Signal level test
This mode of operation allows the signal strength of a single device on the system or all devices globally on
the system to be indicated via the devices on board LEDs. The signal strength level is shown by flashing the
individual devices LED to ascertain the devices signal strength level. This is split into two colours :- green for
'GOOD' signal and red for 'LOW' signal. The signal strength status LED would update periodically to allow an
updated reading to be shown.
View all devices
When entered the screen will show the current settings for the devices on the system. The device listings
can be scrolled through by using the
©2020 EMS Ltd. All rights reserved.
Next available address number on system
The device type followed by the devices unique ident number
(where xx = represents the ident number of the device)
and buttons.
1
3
Page 65 of 80
Default setting
Reset
Reset
MK067-0001-99 (Issue 1) 04/11/2020 AJM
WZM MENUS