Add Devices To The System - EMS SmartCell Programming Manual

Add devices to system
From access level 3 (refer to the 'Access Level 3' section for
details), press the
3
Press the button and the screen will display:
Press the button and the screen will display*:
Press the button and the screen will display:
Insert the device's batteries and the screen will change to
show:
Check that the device ident on-screen matches the device
ident shown on the barcode label. Press
or to cancel. If accepted, the screen will display:
4
Followed by:
Either continue adding new devices (by inserting batteries,
or press until the front screen is displayed.
4
* Refer to the 'WZM menus' section for alternative programming methods.
©2020 EMS Ltd. All rights reserved.
button until the screen displays:
to confirm,
Page 32 of 80
View System Status
Maintenance/Test
Device Options
WZM Settings
Add New Device
Remove Device
Edit Settings
Signal Level Test
At WZM
At Device Location
Configure Devices
Insert Batteries
Into Device
NOW
Add Fire Device ?
Sounder Detector
ID:001234
Add
New FIRE
Device Added
ID:001234
Address 01
Add Another
Device ?
Continue
MK067-0001-99 (Issue 1) 04/11/2020 AJM
<Exit
<Exit