EMS SmartCell Programming Manual page 62

Add new device
This menu allows all wireless device types to be added to the system. The function allows the device to be
added in two different ways. Both methods are shown in more detail below:-
At WZM
This option is used when devices are logged onto the system prior to the devices being installed. The step
by step process is shown below:
A) Log on /adding is undertaken whilst standing in front of the WZM with each device.
B) This involves entering the 'Add WZM' menu, then fit the device's batteries.
C) The device details are then received and displayed on the WZM.
D) Check the device ident number shown on screen against the ident shown on the device's barcode
label. If correct and details are accepted, the device is added to the WZM.
E) The device can then be installed in the required location.
Add Device Location
This option is usually used when the devices have already been installed and the user requires them to be
added to the system via the devices magnetic log on switch. The step by step process is shown below:
A) Log on /adding is undertaken by visiting each installed device.
B) This involves entering the 'Add Device Location' menu and then placing a magnet against the
devices magnetic log on switch. See the 'Magnet log on points' section for device log on points.
C) The device's LED will flash to indicate that the device has successfully communicated with the
WZM.
D) The device details are then received and displayed on the WZM.
E) It is possible to accept the new device, or add another device in the same fashion, therefore creating
a list at the WZM.
F) When these details are accepted, the device is added to the WZM.
©2020 EMS Ltd. All rights reserved. Page 62 of 80 MK067-0001-99 (Issue 1) 04/11/2020 AJM