EMS SmartCell Programming Manual page 60

Sounder O/P Test
This menu option allows the engineer to send individual sounder devices a command to switch its sounder
elements on and off. Individual output devices can also be selected to turn the units relay outputs on and
off.
Note: If the unit is a dual output device, both outputs will operate.
Device Signal List
This menu option allows the engineer to view signal information for all devices on the system. You can
scroll through the list using the and buttons. The signal levels will be shown as GOOD, LOW and NO
1
3
SIGNAL.
Device Battery List
This menu option allows the engineer to view battery information for all devices on the system. You can
scroll through the list using the and buttons. The battery levels will be displayed for each device
1
3
using BATTERY OK, BATTERY LOW and BATTERY MISSING icons.
Edit Service Code
This menu option allows the engineer to change the four digit service code, that is required for entry to
access level 3.
Clear event log
This menu option allows the event log to be cleared.
©2020 EMS Ltd. All rights reserved. Page 60 of 80 MK067-0001-99 (Issue 1) 04/11/2020 AJM