Access Level 3 Entry; Example Menu Display - EMS SmartCell Programming Manual

Access level 3 entry

A valid user access code is required for access level 3. One entered the full service menu access structure is
available at this level. This is shown and detailed fully in this programming manual.
To enter access level 3 press the
Press the relevant numbered arrows to enter the access level 3 access code required ( 1=
4= ). Access level 3 default access code is 333333. On completion of the last number entered, press the
4
button. The display will change to briefly show the display below, then the relevant menu options will be
available. During this display all buttons are immediately active.
By selecting the access level 3 option and entering the correct access 3 entry code additional menus will be
available.

Example menu display

An example display is shown below:
The menus can be navigated by pressing the
the arrow ( ) adjacent to it. Pressing the
Exiting from a menu option is achieved automatically after two minutes, or by pressing the
©2020 EMS Ltd. All rights reserved.
button. The display will change to show:
For Access
Enter Code:
Press To Complete
* Welcome Service *
Access Level 3
Now Available
All Buttons Active
View System Status
Maintenance/Test
Device Options
WZM Settings
and buttons until the desired option to be entered has
1
3
button enters this option.
Page 19 of 80
INTRODUCTION INTRODUCTION
MK067-0001-99 (Issue 1) 04/11/2020 AJM
, 2= , 3= ,
2
1
3
.
button.
4