System Setup Introduction; Important System Setup Notes; Side Cover Removal - EMS SmartCell Programming Manual

System setup introduction

This system setup section
'at WZM' (via power-up) method of adding devices to the WZM will be used. For advanced programming,
refer to the 'Panel Menus' section of this document.

Important system setup notes

The installation must conform to applicable local installation codes and should only be
!
installed by a fully trained competent person.
Always select an appropriate device type for the application as per local codes of practice,
or as advised by a qualified professional.
The procedures outlined in this installation guide must be carefully followed.
SmartCell devices contain electronics that may be susceptible to damage from Electro
Static Discharge (ESD). Take appropriate precautions when handling electronic boards.
To ensure correct operation, products must be used within the specified environmental
operating conditions.

Side cover removal

The following steps illustrate how to remove the side covers:
1.
Slide the side cover sideways,
creating a gap as shown.
©2020 EMS Ltd. All rights reserved.
will show you how to configure the WZM and connect it to a fire alarm panel. The
2.
Position your fingers behind
the cover's protruding edge.
Page 22 of 80
3.
(B)
Press the cover's releasing clip
with your thumb
simultaneously rotate the side
cover anti-clockwise
viewed overhead to remove the
cover.
MK067-0001-99 (Issue 1) 04/11/2020 AJM
(A) (A)
(A), and
(B), as