Add Devices To System - EMS SmartCell Quick Start Manual

Add devices to system

From access level 3 (as previously
shown on page 16), press the
button until the screen displays:
Press the button and the screen
will display:
Press the button and the screen
will display*:
Press the button and the screen
will display:
Insert the device's batteries and the
screen will change to show:
Check that the device ident on-screen
matches the device ident shown on
the barcode label. Press
or to cancel. If accepted, the screen
4
will display:
Followed by:
Either continue adding new devices (by
inserting batteries, or press
front screen is displayed.
* Refer to the 'SmartCell Intelligent Wireless Zone Monitor
Programming Guide' (MK067) for alternative programming methods.
©2020 EMS Ltd. All rights reserved
3
to confirm,
until the
4
Page 19 of 36 MK349-0001-99 (Issue 1) 22/10/2020 AJM
View System Status
Maintenance/Test
Device Options
WZM Settings
Add New Device
Remove Device
Edit Settings
Signal Level Test
At WZM
At Device Location
Configure Devices
Insert Batteries
Into Device
NOW
Add Fire Device ?
Sounder Detector
ID:001234
Add
New FIRE
Device Added
ID:001234
Address 01
Add Another
Device ?
Continue
<Exit
<Exit