Animal Age & Count - Airstream EXPERT PN110 User Manual

EXPERT PN110
Water meters — This menu shows the water
meter consumptions that were measured
every hour for the past 7 days. *This history is
accessible if the water meter is enabled (sec. 4.6.1).
Feeders — This menu shows the feeder run
times that were measured every hour for the
past 7 days. *This history is accessible if feeders
are enabled (sec. 3).
Heaters — This menu shows the heater run
times that were measured every hour for the
past 7 days.
Set Points — This menu shows the tempera-
ture set points that were measured every hour
for the past 7 days.
38
EXPERT PN110 rev.23
12.5. Animal Age & Count
Animal age: Some parameters of the control-
ler can automatically change over time as
the animals grow up (temperature curve for
instance). For this reason, you must set the
animal age as shown below.
Animal count
(current count / mortality / culled / marketed)
At the beginning of a batch, you must specify
the initial number of animals. You will then
be able to adjust the number of animals as
changes occur (mortalities, culled, and mar-
keted animals).
ALL histories of the controller are reset
when a new group starts (i.e., the animal
age switches from 0ff to 1 day).
The animal age automatically goes to
0 day (Off) when entering in Clean Mode.
1. Select:
» AGE & MORTALITY
Age & Mortality
Age: 10 days
New Dead 0
Today's Dead 0
Total Dead 0
New Culled 0
Today's Culled 0
Total Culled 0
New Marketed 0
Today's Market. 0
Current Size 500
Initial Size 500
Dead Yesterday 0
Cul. Yesterday 0
Dead 2 Days ago 0
Cul. 2 Days ago 0
Mark 2 Days ago 0
...
2. Set the following parameters:
Age — Set the animal age. It can be adjusted
from 0 days to 450 days.
New Dead / Culled / Marketed — Enter the
number mortalities, of culled animals and of
marketed animals as it occurs. Once a value
is posted, the parameter displayed on screen
automatically goes back to "0". The posted
value is then removed from the current animal
count and is logged in the respective history
menus (Today & Total Died ,Culled or Mar-
keted history).
Today's Dead / Culled / Marketed — The
controller displays the number of animals that
have died, that have been culled and that have
been marketed since the beginning of the day.
These values cannot be changed.
Total Dead / Culled / Marketed — The control-
ler displays the number of animals that have
died, that have been culled and that have been
marketed since the beginning of the batch.
These values cannot be changed.
Current Size — The current count is automati-
cally adjusted when the number of mortali-
ties, of culled animals and marketed animals
changes.
Initial Size — Specify the initial number of
animals in the room.
7-day History (Dead, Culled & Marketed) — The
controller displays the daily number of dead,
culled and marketed animals for the past 7 days.
These values cannot be modifi ed.