EDAN VE-H100B User Manual page 80

VE-H100B Veterinary Pulse Oximeter User Manual
Cleaning the Oximeter:
Before cleaning the oximeter or the sensor, make sure that
the oximeter is switched off and batteries are taken out.
To surface-clean the oximeter, follow these steps:
1. Switch off the oximeter and take out the batteries.
2. Wipe the entire exterior surface, including the screen, of the
equipment using a soft cloth dampened with the cleaning solution
thoroughly until no visible contaminants remain.
3. Wipe off the cleaning solution with a fresh cloth or towel,
dampened with tap water after cleaning until no visible cleaning
agent remains.
4. Dry the oximeter in a ventilated and cool place.
Cleaning the SpO
1. Wipe the surfaces of the sensor and cable using a soft cloth
dampened with the cleaning solution until no visible contaminants
remain.
2. Wipe the patient contact area of the sensor with the cotton
swab dampened with the cleaning solution until no visible
contaminants remain.
3. Wipe off the cleaning solution with a fresh cloth or towel,
WARNING
Sensor:
2
- 71 -