About Hardware; Hardware Specification - Contec DIG-100M1002-PCI User Manual

6. About Hardware

This chapter provides hardware specifications and hardware-related supplementary information.

Hardware specification

Table 6.1. Specification < 1 / 3 >
Item
Analog input channels
specification
Isolated specification
Type
Number of input channels
Input impedance *1
Input coupling
Input voltage range
Offset ⋅ range setting
Max.input voltage *2
Resolution
Conversion speed *3
Frequency bandwidth
(-3dB)
Noise filtering bandwidth
(-3dB)
AC coupling cut off
frequency (-3dB)
On-board memory
*1 : Switch to 1MΩ automatically when power is turned off.
*2 : Do not input a voltage over the Max. input voltage.
It may cause failure.
*3 : When 2ch are used, the Max. conversion speed is 50MHz (when data logger mode is used.).
DIG-100M1002-PCI
Non-isolated
Single-Ended Input
2ch Synchronized Sampling
You can select 1MΩ±1% // 19pF typ. or 50Ω±2%
AC,DC,GND (AC coupling can be used only when 1MΩ is set.)
< When input impedance 1MΩ is set. >
40mVpk [±20mV], 100mVpk [±50mV], 200mVpk [±100mV], 400mVpk
[±200mV], 1Vpk [±500mV], 2Vpk [±1V], 4Vpk [±2V], 10Vpk [±5V],
20Vpk [±10V], 40Vpk [±20V]
< When input impedance 50Ω is set. >
40mVpk [±20mV], 100mVpk [±50mV], 200mVpk [±100mV], 400mVpk
[±200mV], 1Vpk [±500mV], 2Vpk [±1V], 4Vpk [±2V], 10Vpk [±5V]
Input voltage range's ±50%
(For 1MΩ:40Vpk, 50Ω: 10Vpk: ±0%
When input impedance 1MΩ is set.
±30VDC (Max.)
When input impedance 50Ω is set.
±5.6VDC (Max.)
10bit
100MHz (10nsec) Max.
60MHz typ.
20MHz typ. Attenuation property: Low-Pass Filter
13Hz typ.
16M data
Specification
)
6. About Hardware
57