Step 2 Setting The Hardware; Parts Of The Board And Factory Defaults - Contec DIG-100M1002-PCI User Manual

2. Setup

Step 2 Setting the Hardware

This section describes how to set this product and plug it on your PC.
This product has some switches to be preset.
Check the on-board switches before plugging this product into an expansion slot.
This product can be set up even with the factory defaults untouched. You can change board settings
later.

Parts of the Board and Factory Defaults

Figure 2.1. shows the names of major parts on the board.
Note that the switches and jumpers setting shown below is the factory default.
CH1
CH0
CLK
TRG
Interface connector
(CH0, CH1, CLK, TRG)
CH1
CH0
CLK
TRG
Figure 2.1. Part Names
12
Synchronization control cable
(CN6, CN7)
CN6 CN7
8
cTEST Series Digitizer
DIG-100M1002-PCI
MADE IN JAPAN
Board ID Setting
Switch
SW1
BOARD ID
8
DIG-100M1002-PCI