External Connection; How To Connect The Connectors; Connector Shape - Contec DIG-100M1002-PCI User Manual

3. External Connection

This chapter describes the interface connectors on the product and the external I/O circuits.
Check the information available here when connecting an external device.

How to connect the connectors

Connector shape

To connect an external device to this product, plug the cable from the device into the interface
connector (CH0, CH1, CLK, TRG) shown below.
This product has the following interface connectors: the (CH0, CH1 connector) for analog inputs, (CLK
connector) for reference clock and (TRG connector) for external trigger I/O.
Interface connector
(CH0, CH1, CLK, TRG)
CH1
CH0
CLK
TRG
* Please refer to chapter 1 for more information on the supported cable and accessories.
Figure 3.1. Interface Connector Shape
* Please refer to chapter 1 for more information on the supported cable and accessories.
Figure 3.2. Examples of Connecting Options
DIG-100M1002-PCI
CN6 CN7 CH1
SW1
8
CH0
cTEST Series Digitizer
DIG-100M1002-PCI
CLK
MADE IN JAPAN
TRG
(CH0, CH1, CLK, TRG)
Option
BNC cable
BNC-Bxxx
CH1
CH0
- BNC connector [plug type]
B6252HB-NPP3G-50
[mfd. by AMPHENOL TAIWAN]
or equivalence to it
CLK
TRG
3. External Connection
23