Table of Contents
Advertisement
The Other Function
Event controller
The event controller is a function handled in the digitizer to decide how to combine various control
signals.
Various control signals can be output outside by customizing the combination of control signals.
Such operation as the following examples is possible by the use of the event controller function.
-
The sampling clock of the digitizer is output to synchronization bus or Trigger Output.
-
The reference clock for PLL is output to Reference CLK.
-
A pulse is output to synchronization bus or Trigger Output whenever the acquisition of one record is
completed,
-
The pulse is output to synchronization bus or Trigger Output when the operation of the digitizer is
completed.
-
A pulse is output to synchronization bus or Trigger Output when the pre-trigger or the post-trigger
of the digitizer is satisfied.
-
The result of the waveform comparison (OK/ NG/count match) is output to synchronization bus or
Trigger Output as the pulse or the level.
-
The signal of synchronization bus is output to Trigger Output.
-
A pulse is output to synchronization bus or Trigger Output when the digitizer stops abnormally.
-
Master device or slave device is aborted by conditions such as an error that occurred in the board.
DIG-100M1002-PCI
4. Functions
43
Advertisement
Table of Contents
