Quick Start
4 Set the probe ratio based on the attenuation of the probe, and then click
Auto.
5 Observe the waveform on the display. In normal condition, the square waveform as
shown in the figure below should be displayed.
6 Use the same method to test the other channels. If the square waveforms actually
shown do not match that in the figure above, please perform "Probe
Compensation" introduced in the next section.
Warning
DS70000 User Guide
18
Figure 4.7 To Use the Compensation Signal
Figure 4.8 Waveform Signal
Copyright ©RIGOL TECHNOLOGIES CO., LTD.
All rights reserved.
>