Danfoss VLT AQUA Drive Manual page 17

Hide thumbs Also See for VLT AQUA Drive:

In this lab you will set up a VLT Aqua drive to operate in "Hand Mode". This is the

simplest form of operation and consists of using the drives LCP to operate the

drive manually. You will use the 12 parameter quick setup menu to set up the

basic parameters required for local control.

Learn how to access the FC-202's software quick menus

Program & understand the 12 "Quick Setup" parameters

Run an "AMA" sequence to fine tune the connected motor

Start the drive and change it's speed using the LCP

177R0521-VLT_Aqua_Drive_Training_Handout_BODY.indd 16

VLT Aqua Drive Lab # 1

Introduction

Behavioural Objectives

(local control panel)

4/29/15 2:47 PM

Table of Contents

Need help?

Do you have a question about the VLT AQUA Drive and is the answer not in the manual?