Power Failure Alarm - ZANOLLI TEOREMA POLIS PW Manual For Installation, Use And Maintenance

4. FUNCTION
replaced with those of the alarms . The backlighting changes
from white to red. The cooking cycle currently running is interrupted, given
that it is impossible to get a "valid" temperature for the system. On the first
line of the display, in place of the temperature, three lines are shown (no
temperature detected)
Press the "start" key to bring the system into the "ON"
state; the backlighting goes back to being white but the
alarm symbols continue to be highlighted but do not flash.
NONE OF THE COOKING CYCLES CAN BE ENABLED.
After having identified the fault, it is necessary to turn on
and turn off the system with the "on/off" key to restore all
the system's functions of the system.

4.4.2. Power failure alarm.

If for whatever reason power is cut off at the mains electricity supply the
system behaves as follows:
- during the normal cooking cycle
The cooking timer is memorized by the system every 5 minutes. If the
mains electricity supply should fail, on its being restored, the cooking
process will restart using the last memorized setting. The temporary
parameters that were being input up until the moment when power was
cut off are also restored.
When power is restored the buzzer emits a tone at 10 second intervals
while the symbol beside the timer alternates with the symbol for power
failure for the entire time remaining for the cooking cycle .
- during the cooking cycle with the timer set to infinity
When power is restored, the cooking cycle is restarted without having to
manage any cooking timers. No messages are displayed.
- during the programming phase
When power is restored the system goes into the active state of ON.
- In the active state of ON
When power is restored the system goes into the active state of ON.
- In the inactive state of OFF
TEOREMA POLIS PW 27