Showven SPARKULAR FALL User Manual page 5

2. Error information:
Error information
E0 System IC
E2 Temp. Sensor
E3 P Temp. Over
E4 Time Remain
E5 K Temp. Over
E6 Heat Fail
3. Setting Menu:
Press "MENU" to enter the Setting interface, press the "MENU" button to enter different
options until you return to the main interface
Options
Set DMX Address
Wireless Control
Manual Fountain
4. Advanced Menu:
Press "MENU" 3 seconds to enter the advanced setup interface, press MENU key to enter
different options, wait 3 seconds to return to the main interface
Options
Set Temperature
Auto Heat
Density
Mode Selection
Default Parameter
Chassis temperature is too high to shut
Insufficient granules or remaining time,
Inner core temperature is too high to shut
Range
Set the DMX address, machine become a
1-512
send out DMX signal when its address is
Wireless function switch, you can match
ON/OFF
ON/OFF
Range
500-610
Auto preheat function switch after turn on
ON/OFF
70-100
Factory Mode Factory Mode is factory debugging mode,
User Mode
Press "ENTER" to restore all parameters to
Explanation
Systematic error
Temperature sensor was damaged
down
please swiping time card
down
Heating failed
Explanation
wireless host and can
"1++"
code when shows "ON"
Manual fountain switch , for testing
purposes only
Explanation
Setup inner Core temperature
machine
Adjust the sparks density
User Mode is using mode
the factory settings