Craftsman G10-0R7G-2SB Manual page 70

Set the hold time at zero frequency in the transition between forward and reverse
running.It is shown as following figureÿ
Code
F1.12
This Code is used to determine the running state when the setting frequency is
lower than the lower frequency limit.
0:Running at the lower frequency limit
1:Running at zero frequency.Inverter will Running at zero frequency when the running
frequency is less than the lower frequency limit.When the reference frequency is higher
than or equal to the lower frequency limit again,the Inverter will automatic increase
frequency to run.
Code
F1.13
Fig.6-4 FWD/REV dead time diagram
Action when running frequency is less than
lower frequency limit
Terminal detection selection when power is
Name
Name
on
70
Setting Range
0ÿ^10 00
Setting Range
0ÿ^10 00