Advertisement
[9] SELF DIAG MESSAGE AND TROUBLE CODE
âºíuÇ´
1. Self diag message
A. Saddle Finisher unit
Error
Stapler absent
The stapler is not set.
Staple absent
The staple cartridge has run out of
staples.
Mixed sheets
Sheets of different sizes are deposited
in the compartment.
Overstacking for
The number of sheets in the
stapling
compartment has exceeded the limit
imposed on stapling.
Stack tray
The number of sheets deposited on the
overstacking
delivery tray has exceeded the limit
imposed on the tray (sheets, sets).
Saddle
Remove the stack from the bind tray.
overstacking
More than 10 stacks are deposited on
the folded stack tray.
B. Punch Unit (option)
Error
Waste case full
The amount of waste paper in the waste
case has reached the limit.
Excess water
The amount of waste paper in the waste
case has exceeded the limit.
2. Trouble code
A. Outline
The CPU on the machine's finisher controller PCB is equipped with a mechanism to check the machine condition as needed; when it detects a
fault, the machine communicates the fact to the host machine in the form of a code and a detail code.
The host machine indicates the code on its control panel.
B. Trouble code
F1-00
Console finisher communication trou-
ble
Content
Console finisher communication trouble
Phenomenon
Detail
Communication cable test error after turning
on the power or exiting from DIAG.
Communication error with the console
finisher
Case
Cause
Improper connection or disconnection of
connector and harness between the
machine and the console finisher.
Console finisher control PCB trouble
Control PCB (PCU) trouble
Malfunction due to electrical noise
Check and
Canceled by turning OFF/ON the power.
remedy
Check connectors and harness in the
communication line.
Replace the console finisher control PCB or
PCU PCB.
MX-FNX2/AR-PN1/MX-RBX1 SELF DIAG MESSAGE AND TROUBLE CODE 9 – 1
Condition
Timing of detection
Monitoring at all times
Monitoring at all times
When a sheet of a different
size is placed.
When an extra sheet is
placed.
When an extra sheet is
placed.
When an extra sheet is
placed.
Condition
Timing of detection
During punching.
During punching.
Service Manual
Operation
The staple motor (FFSM) and the staple
shift motor (FSM) will stop.
Normal operation will continue; however,
operation is subject to instructions from
the host machine.
The sheet will be aligned based on
maximum size width and delivered as a
stack.
The sheets will be delivered with stapling.
Normal operation will continue.
Normal operation will continue.
Operation
Normal operation will continue.
Punching will be disabled.
F1-02
Console
finisher
abnormality
Content
Console finisher transport motor abnormality
Phenomenon
Detail
Transport motor trouble
Case
Cause
Motor lock
Motor rpm abnormality
Overcurrent to the motor
Console finisher control PCB trouble
Check and
Use DIAG (SIM3-3) to check the motor
remedy
operation.
F1-03
Console finisher paddle motor (FPM)
trouble
Content
Console finisher paddle motor (FPM) trouble
Phenomenon
Detail
Paddle motor (FPM) operation abnormality
Case
Cause
Motor lock
Motor rpm abnormality
Overcurrent to the motor
Console finisher control PCB trouble
Check and
Use DIAG (SIM3-3) to check the motor
remedy
operation.
Resetting
Set the stapler.
Replace the staple
cartridge; or, set it
correctly.
–
–
Remove the sheets
from the delivery tray.
Remove the stack from
the bind tray.
Resetting
Remove the waste
paper from the waste
case.
Remove the waste
paper from the water
case.
transport
motor
Advertisement
Chapters
