Advertisement
2)
With the paper fold rollers and saddle cam positioned as
shown, mount gears as shown below.
• Align the
mark (either of two
drive gear [3] with the
half of the periphery where gears with a smaller face width
are arranged).
• With the
mark on the saddle cam drive gear [3] aligned
with the
mark on the relay gear [4], align the other
on the relay gear withy the rib of the paper folding roller drive
gear [5].
(4) Saddle Unit
1)
Remove the front cover. (See A.(2).)
2)
Remove the rear cover. (See A.(3).)
3)
Open the jam removal cover [1]; then, remove the two screws
[2] and the right stay [3].
[2]
4)
Turn the fold jam releasing dial assembly [4] to move the paper
retaining plate assembly [5] to the inside.
[4]
5)
Remove the stop ring [6], and detach the timing belt [7].
6)
Disconnect the two connectors [8].
[8]
marks) on the saddle cam
mark on the relay gear [4] (on the
mark
[3]
[4]
[5]
[3]
[2]
[1]
[5]
[6]
[7]
MX-FNX2/AR-PN1/MX-RBX1 DISASSEMBLY AND ASSEMBLY 6 – 5
7)
Remove the three screws [9], and slide out the stapler unit [10]
slightly to the front.
8)
Slide out the saddle unit [11] to the front.
[10]
[9]
(5) Processing Tray Assembly
1)
Remove the processing tray upper cover. (See A.(5).)
2)
Remove the side guide. (See A.(7).)
3)
Remove the two screws [1], and disconnect the five connec-
tors [2].
[1]
[2]
[2]
4)
Pull the processing stopper base [3] to the front, and free the
claw [5] at the front and the claw [6] at the rear of the process-
ing stopper [4].
[6]
[4]
[9]
[11]
[1]
[2]
[5]
[4]
[3]
Advertisement
Chapters
