Table of Contents
Advertisement
8
CHIMNEY AND DRAFT
This furnace must be connected to a chimney certified for use with wood burning heating appliances, a 6-inch diameter
chimney is recommended.
The unit is not to be connected to a chimney flue serving another appliance. If the chimney draft exceeds 0.06 IN.W.C.,
a barometric draft control should be installed on the smoke pipe. Never install a manual damper. The barometric control
must be adjusted so that the maximum draft measured at the furnace outlet does not exceed 0.06 IN.W.C. Excessive
draft can overheat the appliance and reduce burn time. Conversely, a lack of draft can lead to poor combustion and
smoke returns.
9
SAFETY RULES
WARNING! THE INFORMATION GIVEN ON THE CERTIFICATION LABEL AFFIXED TO THE APPLIANCE
ALWAYS OVERRIDES THE INFORMATION PUBLISHED, IN ANY OTHER MEDIA (OWNER'S MANUAL,
CATALOGUES, FLYERS, MAGAZINES OR WEB SITES).
9.1
GENERAL REQUIREMENTS
Make sure the chimney outlet and the pipes are clean and in good condition.
Do not use chemical products or liquids to light the fire.
Do not burn wood coated with paint, glue or chemical products.
Do not burn wastes or flammable liquids such as gasoline, naphtha, motor oil, or other unsuitable
matters.
Do not store wood in the vicinity of the furnace. Respect the required clearances between combustible
materials and the source of heat.
WARNING! THE ASH DRAWER AND EXCHANGERS ACCESS PANEL GET VERY HOT. DO NOT
WARNING: This product can expose you to chemicals including carbon monoxide, which
is known to the State of California to cause cancer, birth defects or other reproductive
harm. For more information go to
12
MANIPULATE WITH BARE HANDS.
www.P65warnings.ca.gov/
Advertisement
Table of Contents
