Lan - D-Link DAP-1360U User Manual

DAP-1360U Wireless N300 Access Point & Router
User Manual

LAN

To configure the router's local interface, go to the Connections Setup / LAN page. On this page,
you can change IPv4 address, configure the built-in DHCP server, or specify MAC address and IP
address pairs.
Figure 65. Configuring the local interface. The IPv4 tab. The Local IP Address section.
Parameter
Mode of local IP
address assignment
IP address
Mask
Gateway IP address
Hostname
Local IP Address
For the Access point, Repeater, WDS, and Client modes only.
Select the needed value from the drop-down list.
Static: the IP address, subnet mask, and the gateway IP address are
assigned manually.
Dynamic: the access point automatically obtains these parameters
from the LAN DHCP server or from the router to which it connects.
The IP address of the access point in the local subnet. By default, the
following value is specified: 192.168.0.50.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
For the Access point, Repeater, WDS, and Client modes only.
The gateway IP address which is used by the access point to connect
to the Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
The name of the device assigned to its IP address in the local subnet.
Page 75 of 158
Configuring via Web-based Interface
Description