Table of Contents
Advertisement
DAP-1360U Wireless N300 Access Point & Router
User Manual
Connections Setup
In this menu you can configure basic parameters of the access point's local area network and
configure connection to the Internet (a WAN connection).
WAN
This page is available for the Router and WISP Repeater modes.
On the Connections Setup / WAN page, you can create and edit connections used by the access
point.
Figure 52. The Connections Setup / WAN page. The advanced mode.
To create a new connection, click the ADD button (
that the connection creation page opens.
To edit an existing connection, in the Connections List section, left-click the relevant line in the
table. On the opened page, on the Basic tab, the mandatory settings of this WAN connection will
be displayed. To view all available settings of the WAN connection, go to the All Settings tab.
Change the needed parameters and click the APPLY button.
To disconnect a connection and establish it again, select the checkbox located to the left of the
relevant line in the table and click the RECONNECT button.
To remove a connection, in the Connections List section, select the checkbox located to the left
of the relevant line in the table and click the DELETE button (
connection on the editing page.
To allow multicast traffic (e.g. streaming video) for a connection, click the IGMP link (for the
description of the page, see the IGMP section, page 125).
) in the Connections List section. Upon
Page 60 of 158
Configuring via Web-based Interface
). Also you can remove a
Advertisement
Table of Contents
