Table of Contents
Advertisement
DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring WDS Function
This configuration step is available for the WDS mode.
1. On the WDS page, in the WDS Mode list, select the WDS function mode.
2. In the WDS Encrytion list, select a type of encryption for data transfer between access
points interconnected via the WDS function. Then enter a key for the specified type of
encryption in the Encryption Key field (a password that will be used to access the
wireless network between the interconnected access points). When the Without
encryption value is selected, traffic between the access points will not be secured.
3. In the Channel list, select the wireless channel number. The same wireless channel for the
interconnected access points should be specified.
4. In the AP MAC field, specify the MAC address of a device connected to the access point
via the WDS function. To specify several MAC addresses, click the ADD button, and in the
line displayed, enter a MAC address.
!
The WDS function parameters must be the same for all interconnected devices.
5. Click the NEXT button to continue or click the BACK button to return to the previous page.
Figure 29. The page for configuring the WDS function.
Page 35 of 158
Configuring via Web-based Interface
Advertisement
Table of Contents
