Safety; Safety Notices; Safety Instructions - Markusson Combimatic Owner's Manual

Combimatic

2 Safety

2 .1 Safety notices

This section contains safety information for the power
IMPORTANT notes that are applicable for the safe operation of the power tool .
WARNING A warning tells you about conditions that can cause injury or death, if you do not obey the
instructions . Do not continue until all conditions are accepted and engaged .
CAUTION A caution tells you about conditions that can cause damage to equipment, if you do not obey the
instructions . Do not continue until all conditions are accepted and engaged .
IMPORTANT Important or noteworthy information that enables trouble-free and optimal use of the power tool .

2 .2 Safety instructions

WARNING Before you install, operate or do maintenance on the power tool, you must read the safety
information in this manual . Obey the instructions in this manual to prevent injuries or damage to the equipment .
WARNING Read all safety warnings, instructions, illustrations, and specifications provided with this power tool .
Failure to follow all instructions listed below may result in electric shock, fire, and/or serious injury . Save all warnings
and instructions for future reference .
WARNING Put the power tool indoors, in a dry area with good light and a flat and level floor . Do not let the
machine become wet or moist . Do not put the power tool near gas, liquids or other materials that can catch fire or
explode .
WARNING Power tool plugs must match the outlet . Never modify the plug in any way . Do not use any adapter
plugs with earthed (grounded) power tools . Unmodified plugs and matching outlets will reduce risk of electric shock .
WARNING The power tool must always be fixed to the floor . Make sure that it is safely attached .
WARNING Do not operate the power tool in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust, or near flammable materials . Power tools create sparks which may ignite such materials .
WARNING The user must only do maintenance that is described in this manual on the power tool . Only
approved and trained service technicians can do service on the power tool .
WARNING Make sure that the power is turned off before you install, operate or perform maintenance on the
power tool .
WARNING If operating a power tool in a damp location is unavoidable, use a residual current device (RCD)
protected supply . Use of an RCD reduces the risk of electric shock .
WARNING To prevent mistakes when chains are sharpened, it is very important to understand how the grinding
machine works . Read the instructions carefully before the power tool is used .
WARNING Use protective glasses – risk of sparks from the power tool when grinding .
WARNING Use ear protection – risk of hearing damage .
WARNING Use safety gloves – risk of cuts from the grinding disc or chain .
WARNING Be careful around moving parts – risk of squeezing .
WARNING Stop the power tool immediately if it does not work correctly!
WARNING Before a chain is sharpened, make sure that the the grinding disc is not cracked, does not vibrate or
wobble . If the grinding disc is damaged it must be replaced immediately, see section 6 .3, "Change the grinding wheel
and fit the grinding wheel guard" . If abnormal vibrations occur during operation, immediately stop the power tool and
check the condition of the grinding disc .
WARNING Attach air hoses and cables with cable clamps, to make sure no one trips over them .
WARNING The supply cord can only be replaced by the manufacturer, or approved and trained service
technicians in order to avoid a safety hazard .
tool . This manual contains WARNINGS, CAUTIONS and
Combimatic_v2_EN_210315 5
Safety