Markusson Combimatic Owner's Manual page 18

Installation
2 . Then insert the rod through the unit and insert
the bottom part of the rod onto the base of the
stand .
3 . To secure the rod, start from the top . Place the
provided nut on the top of the hole and insert
the bolt from the bottom of the rod towards the
top, and then through the nut .
J
E
18 Combimatic_v2_EN_ 210315
4 . Do not completely tighten the bolt . Once the
bolt is in place, slide it into the slot located at
the top part of the stand, then tighten the bolt .
5 . Once the top portion is secured, use the
second set of nuts and bolts to fix the bottom
part of the rod to the stand . After securing both
the bottom and the top, bring the stand back to
an upright position .
6 . There are two air lines to be attached to the
pneumatic chain tensioner: one with an air
fitting unit attached to the end and one without
a fitting .
7 . Insert the line without the fitting through the
hole located on the left side of the stand,
bringing it from back to the front . Route the line
through the back of the rod and insert it into the
pneumatic tensioner until it sits in place .
Now attach the chain holders that will allow you
to keep loops of chain up off of the ground .
Insert the provided long bolts into the holes
located on both sides of the stand and fix them
in place with a 13 mm (0 .5") wrench .
H H
D
Combimatic