Set The Head-Tilt Angle; Set The Top-Plate Angle - Markusson Combimatic Owner's Manual

Combimatic
5 . Make sure the grinding wheel edges match the
shape of the chain type .
• For Ceramic grinding wheels: Use the profile
stone (included in delivery) to shape the
edges on the grinding wheel . Use a
light-sweeping action to shape the edges of
the wheel . Use the provided template to verify
proper radius shape for the specific grinding
wheel being used .
6 . Set the grinding wheel switch to OFF .
7 . Use the profile template to verify that the
grinding wheel has the same profile as the type
of chain to be sharpened .
8 . Repeat steps 4–8 until the grinding wheel
profile is the same as the selected profile on
the profile template .

5 .2 .2 Set the head-tilt angle

Note: Read the specifications from the chain
manufacturer to find out the recommended head-tilt
angle for your chain .
1 . Use an adjustable wrench to loosen the
head-tilt angle nut located on the back of the
machine .
2 . Turn the grinding head to set the desired
head-tilt angle (50–90°) on the head-tilt angle
scale . The default head-tilt angle is 60° .
3 . Tighten the head-tilt angle nut .

5 .2 .3 Set the top-plate angle

Note: Read the specifications from the chain
manufacturer to find out the recommended top-plate
angle for your chain .
1 . Use the hex key (provided with the machine) to
loosen the top-plate angle screw up to three
turns .
Combimatic_v2_EN_210315 23
Operation