Insert The Chain - Markusson Combimatic Owner's Manual

Operation
2 . Turn the grinding head to set the desired
top-plate angle (0–35°) on the top-plate angle
scale . The default top-plate angle is 30° .
3 . Tighten the top-plate angle screw .
4 . Press the grinding head positioning button to
move the grinding head in both directions and
make sure that the top-plate angles are the
same .
5 . If the top-plate angles are not the same (for
example 26° in the right direction and 30° in
the left direction), adjust the nuts (A) a 1/2-turn
at the time .
24 Combimatic_v2_EN_ 210315
A
6 . Repeat steps 2–5 until the top-plate angles are
the same in both directions .

5 .2 .4 Insert the chain

CAUTION Always wear safety gloves,
protective glasses, and any other personal
protective equipment suitable for the current
work task .
1 . Check the chain for double cutters (2 left
cutters or 2 right cutters) or double tie straps,
and make sure that the chain is not damaged .
Mark double cutters or double tie straps to
make it easier to see them when the chain is
sharpened .
2 . Place the chain, with the cutter to the left of the
depth gauge, into the groove on the chain vise .
3 . Pull the chain around by hand to make sure
that it runs freely in the chain vise and does
not wobble .
CAUTION! If the chain does not run freely,
or if the chain is forced down into the groove by
pressure from the air tensioner, it can get caught
during the feed .
Combimatic