Table of Contents
Advertisement
Troubleshooting
7 Troubleshooting
7 .1 Troubleshooting procedure
1 .
Make sure that the machine has sufficient power .
2 .
Read section 7 .3, "Issues" and section 7 .4, "Troubleshooting indicators" to find a description of the issue .
3 .
Perform the recommended corrective procedures .
4 .
Perform a sharpening test, see instruction in section 7 .2, "Sharpening test" .
5 .
If the problem persists after corrective procedures, contact your regional sales representative to reach your
service team .
7 .2 Sharpening test
WARNING Stop the machine immediately if it does not work correctly!
Always do a sharpening test:
• when the machine is new,
• to learn how to use the machine, or
• if the chain is not sharpened as expected .
Recommendation: Use an old chain for the test .
1 .
Insert a test chain into the machine and sharpen it according to the instructions in section 5, "Operation" .
2 .
Test the functions of the machine and study its motions .
3 .
Make sure that:
• the right (outer) and left (inner) cutters are sharpened to even lengths . Use a slide-gauge to measure . If they
are uneven, see section 5 .2 .10, "Set the grinding length" .
• the grinding depth on the chain is deep enough . If the grinding wheel is worn, it needs to be adjusted, see
section 5 .2 .9, "Center the grinding disc" . If it needs to be changed, see section 6 .3, "Change the grinding
wheel and fit the grinding wheel guard" .
4 .
Repeat the sharpening test until you see satisfactory test results, and the machine is running trouble-free .
5 .
Remove the test chain .
38 Combimatic_v2_EN_ 210315
Combimatic
Advertisement
Table of Contents
Troubleshooting
