Depth Gauge Grinding - Markusson Combimatic Owner's Manual

Operation

5 .4 Depth gauge grinding

1 . Change the grinding wheel to
See section 4 .7, "Install and center the grinding
wheel" .
2 . Shape the edges of the grinding wheel to make
sure that the shape is correct . See section 5 .2 .1,
"Prepare the grinding wheel" .
3 . Set the top plate angle to 0° . (See 5 .2 .3, "Set the
top-plate angle")
4 . Set the head tilt angle to 60° . (See 3 .6 .1,
"Grinding speed knob")
5 . Remove the screw holding the chain pusher .
Remove the chain pusher . Attach the shorter
change pusher . Attach and fasten the screw .
6 . Change the grinding setting for the height of the
depth gauges . See 6 .4, "Set the depth gauge
height"
32 Combimatic_v2_EN_ 210315
9,5 mm
7 . Adjust the feed so that the grinding wheel
touches the depth gauge .
8 . Make the grinding settings according to the
manufacturer's recommendations .
Combimatic