Installation; Safety During Installation; Site Requirements; Unpack The Machine - Markusson Combimatic Owner's Manual

Combimatic

4 Installation

4 .1 Safety during installation

WARNING Before you install, operate or do maintenance on the machine, you must read the safety information
in this manual . Obey the instructions in this manual to prevent injuries or damage to the equipment .
WARNING Always wear safety gloves, protective glasses, and any other personal protective equipment
suitable for the current work task .

4 .2 Site requirements

WARNING Put the machine indoors, in a dry area with good light and a flat and level floor . Do not let the
machine become wet or moist . Do not put the machine near gas, liquids or other materials that can catch fire or
explode .
WARNING The machine must always be fixed to the floor . Make sure that it is safely attached .
Note: Machines can be set up on a bench or you can use the included stand . Please note that mounting hardware
for the bench is not supplied with the machine .

4 .3 Unpack the machine

Note: For a video demonstration of how to unpack, assemble, install, and operate the machine, visit Markusson .se
1 . Unpack the crates .
Note: Keep the delivery crates and packing materials . Pack the machine in them if it is moved or sent for service .
The crates and packing materials will minimize the risk of damage during transportation .
2 . Make sure that all parts in the list below are included in the delivery:
• Combimatic Auto Chain Grinder machine
• stand (with set of screws, nuts and bolts for assembly)
• pneumatic tensioner, air tubes, and 2 nipples for different types of compressors
• converter (with 2 screws for assembly)
• Combimatic Auto Chain Grinder User manual (this document)
• rectangular profile stone (55 x 15 x 15 mm), profile template (white for 3/4 chains and red for .404 chains)
and transport lock
• a chain pusher for depth gauge grinding
• toolkit with : hex key, which is used to change the top-plate angle
Allen wrench, which is used for tightening
feeler gauge (0 .05 mm), which is used for adjusting the wire
• grinding wheel guard, mounted
• 3 types of ceramic grinding wheels
• screws, nuts and bolts for assembly
Note: For your convenience, you may also use your own tools to assist the machine's assembly .
3 . Remove all packing materials . Leave only the cable ties and the transportation lock that holds the grinding head
in place . Remove the air hose connector's packing material .
Combimatic_v2_EN_210315 15
Installation