Table of Contents
Advertisement
TROUBLESHOOTING
Chain is not fixed during sharpening = Chain looking device must be tightened. Tighten
the M6 nut (1) on the back of the machine. Start with 1 turn clockwise, a bit more if
needed. (See picture below)
Grinding angle shows for example 35
the grinding head.
This is adjusted with a pair of M6 nuts (2). Adjust in steps of ½-turn. Turn the head left to
right and control the grinding angle. Adjust until angle is the same in both directions. (See
picture above)
.
Always turn power off!
°
More thorough servicing or troubleshooting
must be done by the dealer's servicing team.
in one direction and 25
21
in the other when turning
°
Advertisement
Table of Contents
