Installing The Sharpening Machine; Cutting Angle; Grinding Angle - Markusson combiMatic User Manual

INSTALLING THE SHARPENING MACHINE

Install the machine on a working bench or a stand.
NOTE:
The machine must be securely fastened. The machine must be fixed in
line with or 1-5mm outside of the edge of the working bench.

CUTTING ANGLE

The cutting angle can be set between 90°and 50°. Loosen the nut on the back (1)
and turn the grinding head to the correct degree marking and then tighten the
nut.

GRINDING ANGLE

The grinding angle can be set between 0
loosen the allen screw (1). NOTE: Max three (3) turns. Turn the grinding head
to the desired angle. Tighten the allen screw again (1).
The machine must not be located close to
gas, liquids or other materials that
might catch fire or explode.
-35
° °
8
. If You want to change the angle,